Enterasys Networks 1G58x-09 - Manual (Page 565)

IP Configuration Command Set
Reviewing and Saving the Routing Configuration
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 12-9
Syntax Description
None.
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan ))#
Command Defaults
None.
Example
The following example shows how to enable VLAN 1 for IP routing:
12.2.2 Reviewing and Saving the Routing Configuration
Purpose
To review and save the current routing configuration, and to disable IP routing.
Commands
The commands needed to review and save the routing configuration are listed below and described
in the associated section as shown:
• show running-config ( Section 12.2.2.1 )
• write ( Section 12.2.2.2 )
• no ip routing ( Section 12.2.2.3 )
NOTE: The shutdown form of this command disables an interface for IP routing.
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#no shutdown