Enterasys Networks 1G58x-09 - Manual (Page 212)

Port Configuration Command Set
Configuring Link Aggregation
4-66 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4.3.13.4 show port lacp
Use this command to display link aggregation information for one or more underlying physical
ports.
show port lacp {[port-string] [counters port-string] [detail port-string]}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display LACP status information f or all Gigabit Ethernet ports. In this
case, ports ge.0.1 and ge.0.2 have been statically assigned to an aggregator (lag.0.1), but not
attached, as indicated by the asterisks placed in the aggregator names:
port-string Displays LACP information for specific port(s). For a
detailed description of possible port-string values, refer
to
Section 4.1.2 .
counters port-string Displays LACP counter information for one or more
ports.
detail port-string Displays detailed LACP status information for one or
more ports.
Matrix>show port lacp ge.0.*
Port Key State Agg POSysID POKey LACPRxTx
--------------------------------------------------------------------------
ge.0.1 100 -F---AlA l*g.0.1 00:00:00:00:00:00 1 Disabled
ge.0.2 100 -F---AlA l*g.0.1 00:00:00:00:00:00 1 Disabled
ge.0.3 100 -F--SAlA ------- 00:00:00:00:00:00 3 Enabled
ge.0.4 100 -F--SAlA ------- 00:00:00:00:00:00 4 Enabled
ge.0.5 100 -F--SAlA ------- 00:00:00:00:00:00 5 Enabled
ge.0.6 100 -FDCSAlA ------- 00:00:00:00:00:00 6 Enabled