Enterasys Networks 1G58x-09 - Manual (Page 590)

IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
12-34 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
This example shows how to set IP address 10.1.2.3 as the next hop gateway to destination address
10.0.0.0. The route is set as permanent and assigned a tag of 20:
This example shows how to set VLAN 100 as the next hop interface to destination address 10.0.0.0:
12.2.5.7 ip icmp
Use this command to re-enable the Internet Control Message Protocol (ICMP), allowing a router to
reply to IP ping requests. By default, ICMP messaging is enabled on a routing interface for both
echo-reply and mask-reply modes. If, for security reasons, ICMP has been disabled using no ip
icmp, this command will re-enable it on the routing interface.
ip icmp {echo-reply | mask-reply}
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command disables ICMP:
no ip icmp {echo-reply | mask-reply}
Command Type
Router command.
Matrix>Router(config)#ip route 10.0.0.0 255.0.0.0 10.1.2.3 permanent tag 20
Matrix>Router(config)#ip route 10.0.0.0 255.0.0.0 vlan 100
echo-reply Enables ICMP in echo-reply mode.
mask-reply Enables ICMP in mask-reply mode.