7 set spantree msti, 8 clear spantree msti, Set spantree msti -13 – Enterasys Networks 1G58x-09 User Manual
Page 299: Clear spantree msti -13, Section 6.2.1.7, Section 6.2.1.8, Command
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
6-13
6.2.1.7
set spantree msti
Use this command to create or delete a Multiple Spanning Tree instance.
set spantree msti sid {create | delete}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create MST instance 2:
6.2.1.8
clear spantree msti
Use this command to delete one or more Multiple Spanning Tree instances.
clear spantree msti [sid]
Syntax Description
Command Defaults
If sid is not specified, all MST instances will be cleared.
sid
Sets the Multiple Spanning Tree ID. Valid values are 1 -
4094.
NOTE: Matrix E1 devices will support up to 16
MST instances.
create | delete
Creates or deletes an MST instance.
Matrix>set spantree msti 2 create
sid
(Optional) Deletes a specific multiple Spanning Tree ID.