Enterasys Networks 1G58x-09 - Manual (Page 379)

VLAN Configuration Command Set
Assigning VLANs According to Classification Rules
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-37
Syntax Description
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to
Table 7-2 .
Command Type
Switch command.
Command Mode
Read-Write.
Command Alternative (v2.05.xx and higher)
clear policy port ( Section 8.3.3.3 )
Example
This example shows how to remove Fast Ethernet front panel port 21 from the Source UDP Range
classification rule to filter out (drop) incoming frames:
vlan-id Specifies the number of the VLAN to remove from the
classification rule.
port-string Specifies the port(s) to remove from the classification
rule. For a detailed description of possible port-string
values, refer to
Section 4.1.2 .
data_meaning Specifies the data_meaning for the parameter used to
classify or filter frames. Refer to
Table 7-1 and Table 7-2
for lists of the data_meanings and associated protocol
types and classifications.
data _value Specifies the code of a predefined classifier. The range of
values is dependent on the data_meaning. Refer to
Table 7-1 and Table 7-2 for the limitations.
data_mask (Not required for most data values.) This entry is
dependent on the data_value entered. For details, refer to
Table 7-2 .
Matrix>clear vlan classification ingress 6 fe.0.21 src-udp-range 45 53