Enterasys Networks 1G58x-09 - Manual (Page 178)

Port Configuration Command Set
Setting Flow Control and Thesholds
4-32 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
threshold (Cont’d) • EgressGeneral - controls the buffer allocations for
unicast frames destined to a single egress port, for
multicast frames queued for egress per device, and for
frames destined for routing ports.
• ResetAll - resets all threshold types.
portgroup Specifies the port group on which buffer thresholds will be
set as:
• fe - Fast Ethernet
• ge - Gigabit Ethernet, or
• all
queue0 - queue3 Sets the percentage to allocate to each of four priority
queues. Valid values are 1 to 100, rounded to the nearest
0.1%, and must be entered in decimal format: 00.0. If the
sum of these percentages is greater than 100%, then buffer
sharing is allowed amongst the queues.
receive-buffer When the IngressRX threshold type is chosen, sets the
percentage of buffers a port is allowed to use. Valid values
are 1 to 100, rounded to the nearest 0.1%, and must be
entered in decimal format: 00.0. Receive-buffer percentage
must be higher than the xoff-limit, which must be higher
than the xon-limit.