Enterasys Networks 1G58x-09 - Manual (Page 251)

SNMP Command Set
Configuring SNMP Access Rights
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-29
5.2.3.2 set snmp access
Use this command to set an SNMP access configuration.
set snmp access groupname security-model {v1 | v2 | v3 {noauth | auth |
authpriv}} [read read] [write write] [notify notify] [volatile | nonvolatile]
Security Level Security level applied to this group. Valid levels
are:
• noauth — No authentication or privacy
protocol required.
• auth — Authentication but no privacy protocol
required.
• authpriv — Authentication and privacy
protocol required.
Storage Type Whether access entries for this group are stored in
volatile, nonvolatile or read-only memory.
Row Status Status of this entry: active, notInService, or
notReady.
Read View Name Name of the view that allows this group to view
SNMP MIB objects.
Write View Name Name of the view that allows this group to
configure the contents of the SNMP agent
.
Notify View Name Name of the view that allows this group to send an
SNMP notification. This can be configured with
the set snmp notify command as described in
Section 5.2.7.7 .
Table 5-7 show snmp access Output Details (Continued)
Output What It Displays...