Enterasys Networks 1G58x-09 - Manual (Page 303)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-17
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the VLAN(s) mapped to Spanning Tree 1. In this case, VLANs
2, 16 and 42 are mapped to SID 1. For this information to display, the SID instance must be created
using the set spantree msti command as described in
Section 6.2.1.7 , and the FIDs must be mapped
to SID 1 using the set spantree mstmap command as described in Section 6.2.1.10 :
6.2.1.13 show spantree mstcfgid
Use this command to display the MST configuration identifier elements, including format selector,
configuration name, revision level, and configuration digest.
show spantree mstcfgid
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
sid Specifies a Multiple Spanning Tree ID. Valid values are 1 -
4094, and must correspond to a SID created using the set
spantree msti command as described in
Section 6.2.1.7 .
Matrix>show spantree vlanlist 1
The following VLANs are assigned to SID 1: 2 16 42