30 show spantree legacypathcost, 31 set spantree legacypathcost, Show spantree legacypathcost -29 – Enterasys Networks 1G58x-09 User Manual
Page 315: Set spantree legacypathcost -29, Section 6.2.1.30, Section 6.2.1.31
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
6-29
Example
This example shows how to reset automatic edge port detection to enabled:
6.2.1.30 show spantree legacypathcost
Use this command to display the status of the legacy (802.1D) path cost setting.
show spantree legacypathcost
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of the legacy path cost setting:
6.2.1.31 set spantree legacypathcost
Use this command to enable or disable legacy (802.1D) path cost values.
set spantree legacypathcost {disable | enable}
Syntax Description
Command Defaults
None.
Matrix>clear spantree autoedge
Matrix>show spantree legacypathcost
Legacy path cost is currently enabled.
disable | enable
Disables or enables legacy (802.1D) path cost values.