Enterasys Networks 1G58x-09 - Manual (Page 49)

Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-1
3
Startup and General Configuration
This chapter describes factory default settings and the Startup and General Configuration set of
commands.
3.1 STARTUP AND GENERAL CONFIGURATION SUMMARY
At startup, the Matrix E1 device is configured with many defaults and standard features. The
following sections provide information on how to review and change factory defaults, how to
customize basic system settings to adapt to your work environment, and how to prepare to run the
device in router mode.
3.1.1 Factory Default Settings
The following tables list factory default device settings available on the Matrix E1. Table 3-1 lists
default settings for basic operation and for when the device is in switch mode. Table 3-2 lists default
settings for router mode operation.
Table 3-1 Default Device Settings for Basic and Switch Mode Operation
Device Feature Default Setting
802.1X Disabled.
CDP (Enterasys)
Discovery Protocol Auto enabled on all ports.
CDP interval Transmit frequency of CDP messages set to 60 seconds.
Cisco Discovery
Protocol Disabled.
DNS Enabled.
Community name Public.