Enterasys Networks 1G58x-09 - Manual (Page 512)

Logging and Network Management Command Set
Managing Switch Network Addresses
11-42 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2.3.8 clear mac
Use this command to clear dynamic MAC address information for the switch.
clear mac [address mac_address vlan_id | port port-string | vid vlan_id
port-string]
Syntax Description
Command Defaults
If no parameters are specified, all dynamic MAC address entries will be cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to clear all dynamic MAC address information:
address
mac_address
vlan_id (Optional) Removes all dynamic MAC address entries
attached to the specified VLAN.
If you enter a multicast MAC address and ingress VLAN
pair, this command will clear the scoping of this pair to an
egress VLAN configured with the set mac multicast
command (
Section 11.2.3.24 ).
port port-string (Optional) Removes all dynamic MAC address entries
attached to the specified port(s). For a detailed description
of possible port-string values, refer to
Section 4.1.2 .
vid vlan_id
port-string (Optional) Removes all dynamic MAC address entries
attached to the specified VLAN on the specified port(s).
Matrix>clear mac