Enterasys Networks 1G58x-09 - Manual (Page 298)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-12 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the version of the Spanning Tree protocol to MSTP:
6.2.1.6 show spantree mstilist
Use this command to display a list of Multiple Spanning Tree (MST) instances configured on the
device.
show spantree mstilist
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display a list of MST instances. In this case, SID 2 has been configured:
Matrix>clear spantree version
Matrix>show spantree mstilist
Configured Multiple Spanning Tree instances:
2