Grass Valley PDR 200 Service Manual - Manual (Page 99)

Profile Chassis
PDR 200 Service Manual 6-7
WARNING: To prevent injury, two people are required to lift the PDR200. It is too
heavy for one person to remove from or install into the rack.
5. Depress the stop latches and being careful to fully support the it, slide the chassis
completely out of the rack and place on a flat, level surface.
To install the chassis:
WARNING: To prevent serious injury, insure that the rack is anchored to the floor
so that it cannot tip over when the PDR 200 is extended out of the rack.
WARNING: To prevent injury, two people are required to lift the PDR200. It is too
heavy for one person to remove from or install into the rack.
1. Align the chassis slides with those on the rack and slide the chassis in until the stop
latches engage (Figure 6-4).
2. Depress the stop latches and slide the chassis completely into the rack.
3. Use the retaining screw to secure the chassis to the rack (Figure 6-3).
4. Reconnect all necessary cables.
5. Reconnect the power cord and turn power On.
!
!
!