Grass Valley PDR 200 Service Manual - Manual (Page 26)

Chapter 2 Specifications
2-6 PDR 200 Service Manual
Table 2-5. Program Input Genlock
Characteristics Description
Burst Frequency Lock Range Requirement:
±
50 Hz at subcarrier
Supplemental Data:Remains locked or initial lock
Signal Amplitude Lock
Range Requirement: Stays locked to +6 dB and -3 dB
Phase Jitter (Analog Input and
Analog Output) Requirement:
≤
1
°
Phase Jitter (Analog Output
Only) Requirement:
≤
0.5
°
Hum Rejection Requirement:
≥
32 dB
Recovery Time Requirement: Fast - Within 35.7 mV in 2 to 3 lines
Medium - Within 35.7 mV in 10 to 30 lines
Slow - Within 35.7 mV in > 30 lines
Switch Points Requirement: Fast - Medium 30 to 40 dB signal-to-noise
Supplemental Data:Medium - Slow 20 to 30 dB signal-to-noise
Table 2-6. Analog Input/Output
Characteristics Description
Program Input Return Loss Requirement:
≥
40 dB to 5 MHz
Program Output Return Loss Requirement:
≥
40 dB to 5 MHz
Table 2-7. Component Analog Video Input
Characteristic Specification
Input connectors: BNCx (3) terminating
Impedance: 75 ohms
Return loss:
≤
-40dB to 5.0MHz
Input formats
supported (525/60): Betacam
Betacam without setup
Betacam (non-EBU)
MII
MII without setup (SMPTE/EBU-N10)
GBR (700mv no setup)
Input formats
supported (625/50): SMPTE/EBU-N 10
Betacam (non-EBU)
GBR (700mv no setup)
Reference: Sync on Y/G video input