Grass Valley PDR 200 Service Manual - Manual (Page 103)

LED Board
PDR 200 Service Manual 6-11
To replace the LED board:
1. Use the Torx tool with the T10 tip to attach the LED board to the front panel
(Figure 6-7).
2. Reconnect the previously removed cables to the board.
3. Being careful to support the front panel, position the front panel at the chassis and
reconnect the LED cable connector to the board (Figure 6-6)
4. Use the Torx tool with the T15 tip to attach the handles and front panel to the chassis
with the mounting screws, two on each side to the chassis.
5. Slide the PDR 200 into the chassis and tighten the retaining screw (Figure 6-3,
page 6-6).
6. Reconnect the power cord and turn power On.