Grass Valley PDR 200 Service Manual - Manual (Page 25)

Electrical Specifications
PDR200 Service Manual 2-5
Table 2-4. Analog Composite Video E-to-E (Direct)
(Valid for Customer-installed Composite Output or Digital Component Input/Analog Composite Output)
Characteristics Description
Program Gain Requirement: 1
±
3% Direct or AGC Path
Supplemental Data:Typically 1
±
1%
Program Input Gain Range Requirement: 70% to 140% or Better Direct or AGC Path
Supplemental Data:Approximately
±
3 dB
Frequency Response Requirement: 500 kHz to 5.8 MHz
±
6% Direct or AGC Path
Supplemental Data:-3 dB Nominally 6.25 MHz
Signal-to-Noise Ratio Requirement: > 50 dB Direct
> 45 dB AGC Path
Chrominance-to-Luminance
Delay Error Requirement:
≤
30 ns Direct or AGC Path
Supplemental Data:Typically
≤
10 ns
Differential Gain Requirement:
≤
3% Direct or AGC Path
Supplemental Data:Typically
≤
1%
Differential Phase Requirement:
≤
3
°
Direct or AGC Path
Supplemental Data:Typically
≤
1
°
K-Factor Requirement:
≤
3% Direct or AGC Path
Supplemental Data:Typically
≤
1%
2T Pulse-to-Bar Ratio Requirement:
≤
3% Direct or AGC Path
Supplemental Data:Typically
≤
1%
Output Timing Range Requirement: -21/2H to +148H
Supplemental Data:Independent for each output
Supplemental Data:Resolution;
≈
0.3
°
of 3.58 MHz
Supplemental Data:Timing Stability: 1
°
Sync and Burst Insertion Requirement: Meets RS-170A, and CCIR RPT 624-3; always on
Insertion Phase Error Requirement:
≤
3
°
Direct or AGC Path
Chrominance Phase Error
with Reference Burst
Frequency Change Requirement:
≤
3
°
with an input burst frequency change
of
±
10 Hz Direct or AGC Path
Supplemental Data:Typically
≤
1
°
Chrominance Phase Error
with Reference Signal
Amplitude Change Requirement:
≤
3
°
with a
±
3 dB amplitude change
Direct or AGC Path
Supplemental Data:Typically
≤
1
°
DC Offset Requirement:
≤±
50 mV Direct or AGC Path
Inserted Sync and Burst
Amplitude Accuracy Requirement: Sync Direct or AGC Path
NTSC 40 IRE
±
3 IRE
PAL 300 mV
±
21 mV
Burst Direct or AGC Path
NTSC 40 IRE
±
3 IRE
PAL 300 mV
±
21 mV
Supplemental Data:Typically
Sync
NTSC 40 IRE
±
1 IRE
PAL 300 mV
±
7 mV
Burst
NTSC 40 IRE
±
1 IRE
PAL 300 mV
±
7 mV
Inserted Sync and Burst
SCH Phase Accuracy Requirement: 0
° ±
15
°
Direct or AGC Path
Supplemental Data:Typically 0
° ±
5
°
Black Level Error Requirement:
±
0.5 mV Direct
±
15 mV AGC Path