Grass Valley PDR 200 Service Manual - Manual (Page 87)

Replacing the PDR200 Filters
PDR 200 Service Manual 5-5
8. Disconnect the power LED cable from the front panel. See Figure 5-3.
Figure 5-3. Power LED Cable and Filter Removal
9. Remove the air filter strip along the bottom of the panel and the one across the face
of the panel.
Replacing the PDR200 Filters
Once the filters have been cleaned, reinstall the filters and front panel as follows:
1. Attach the air filters to the velcro fasteners in the front panel (Figure 5-3).
1. Reconnect the power LED cable.
2. Use the Torx tool with the T10 tip to reattach the metal gasket with the two screws
previously removed (Figure 5-2).
3. While supporting the front panel, reconnect the LED cable from the front panel to the
chassis.
4. Use the Torx tool with the T15 tip to reattach the front panel and handles with the
screws that secure the handles and front panel to the chassis.
5. Slide the PDR200 all the way back into the rack and tighten the retaining thumb screw
(Figure 5-1).
9675-22
1
Disconnect
LED cable
2
Separate air filters(2) from
velcro fasteners and remove.