Grass Valley PDR 200 Service Manual - Manual (Page 130)

Chapter 6 Parts Removal and Replacement
6-38 PDR 200 Service Manual
Mouse/Keyboard EMI Board
The Mouse and Keyboard EMI board assists in maintaining the environmental
integrity of the PDR200 with a mouse and keyboard connected to the rear panel.
Removal and installation requires removal of both covers and removal of as many
boards as necessary to access the Mouse/Keyboard EMI board.
To remove the Mouse/Keyboard EMI board:
1. Turn PDR200 power Off and disconnect the power cord.
2. Perform the procedure to remove the Profile chassis from the rack (page 6-6).
3. Remove the Profile chassis covers (page 6-8).
4. Remove as many boards as necessary to access the Mouse/Keyboard EMI board
(page 6-33).
5. Use the Torx tool with the T10 tip to remove the screws which secure board to the rear
panel (1 in Figure 6-25) and lift the board up and out of the chassis.
6. Disconnect the cable to the Mouse/Keyboard EMI board (2 in Figure 6-25).
Figure 6-25. Removal of the Mouse/Keyboard EMI Board
9675-12
1
2
Remove
screws(2)
Unplug cabling and
remove EMI board.