Adept s800 s800 User Manual
Page 88
Chapter 6: Optional Equipment Installation
Figure 6-12. Solenoid Placement Using Mounting Hardware
9. Install the appropriate lengths of 5/32 inch plastic tubing (supplied) into the two output
ports on the manifold.
l
Route the tubing up along the tower bracket next to the quill and down through
the center of the quill.
l
Use cable ties as needed to secure the tubing.
10. For the IP-65 version robot, skip to Step 15.
11. Remove the four screws from the User Connector Panel (see Figure 6-3) and remove the
cover enough so you have access to the tubing under the cover. See Figure 6-13.
Figure 6-13. Connecting Spare Air Line to User Connector
Adept Cobra s800 Inverted Robot User's Guide, Rev H1
Page 88 of 142