Adept s800 s800 - Manual (Page 28)

Chapter 3: System Installation
3.2 Cable and Parts List
Table 3-1. Cable and Parts List
Part Description Notes
IEEE 1394 Cable, 4.5 M Standard cable—
supplied with system
XSYS Cable, AIB only, 4.5 M Standard cable—
supplied with AIB
system
eAIB XSYS Cable, 4.5 M Standard cable—
supplied with eAIB
system
eAIB XSLV Adapter Cable,
250 mm Standard adapter cable
for AIB-eAIB upgrade
Front Panel Cable, 3 M Supplied with Front
Panel
T1/T2 Pendant Adapter Cable Supplied with Adept
T2™ pendant (option)
Power Cable Kit - contains
24 VDC and AC power cables Available as option
XIO Breakout Cable, 12 inputs/
8 outputs, 5 M Available as option—see
XIO Breakout Cable on
page 50.
Y Cable, for XSYS cable
connections to dual robots—
requires two eAIB XSLV cables
for an eAIB Available as option—see
Adept Dual-Robot
Configuration Procedure
.
3.3 Installing the SmartController
Refer to the Adept SmartController User's Guide for complete information on installing the Adept
SmartController. This list summarizes the main tasks.
1. Mount the SmartController and Front Panel.
WARNING: Ensure that the front panel is located
outside of the workcell and outside of the work envelope.
2. Connect the Front Panel to the SmartController.
3. Connect the pendant, if purchased, to the SmartController.
Adept Cobra s800 Inverted Robot User's Guide, Rev H1
Page 28 of 142