Turning Technologies ExamView - Manual (Page 76)

ExamView Test Generator 76
5 Click OK.
TIP
With ExamView Test Generator (as with other word processors), it is possible to create a
table where some columns go past the right margin. In these instances, you can't use the
mouse to adjust the cell width. You can use the Cell Height and Width command to set the
cell width for those cells you cannot access with the mouse.
How to adjust table cell height and width using the mouse...
1 To set the cell width using the mouse:
a Select a cell if you want to change the width for that cell only. To set the cell width for all cells in a column, select
the column or make sure that no individual cells are selected.
b Position the mouse pointer on either the left or right cell border. When the pointer changes to a resize cursor, hold
down the mouse button to drag the border to the new location. Alternatively, you can drag the cell column
indicators shown on the ruler.
Resizing one cell using grid lines:
Resizing a single cell Cell width after resizing
Resizing a column using grid lines:
Resizing a column After resizing
Resizing a column using ruler controls:
2 To set the row height using the mouse:
a Position the mouse pointer on the bottom edge of a row border.
b When the pointer changes to a resize cursor, drag the border to the new location. This has the same effect as
changing the row height to “At least” the positioned value.
turningtechnologies.com/user-guides