Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 63)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 3-5
Privileged Mode
debug
debug portmon all
Use the debug portmon all command allows the user to monitor all traffic of a specific type. All
traffic can be displayed, or a specific traffic type can be defined. Note: Immediately after this
command is issued, any traffic that falls into the filter parameter will be displayed. To turn the
monitoring off, you must issue a no debug portmon command. See no debug portmon command
on page 3-16.
Syntax:
# debug portmon all [all|arp address|bootp address|control
|data|dns address|icmp address|ip address|link|mgcp address|
rip address|sip address|stp|tcp {address|address:port|port}|
udp { address|address:port|port}]
Example:
adit 3500# debug portmon all rip 192.168.1.20
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
Filters all traffic of the following type.
all
Allows all traffic.
arp Displays all Address Resolution Protocol traffic.
address = IP address of the interface.
bootp Displays BootP related traffic.
address = IP address of the interface.
control Displays control related traffic.
data Displays data related traffic.
dns Displays Domain Naming Service related traffic.
address = IP address of the interface.
icmp Displays Internet Control Message Protocol related traffic.
address = IP address of the interface.
ip Displays Internet Protocol related traffic Note: Requires an IP address.
address = IP address of the interface.
link Displays link related traffic.
mgcp Displays Media Gateway Control Protocol related traffic.
address = IP address of the interface.
rip Displays Routing Information Protocol related traffic.
address = IP address of the interface.
sip Displays Session Initiation Protocol related traffic.
address = IP address of the interface.
stp Displays Spanning Tree Protocol related traffic.
tcp Displays Transmission Control Protocol related traffic.
address = IP address of the interface.
address:port = IP address
port = Port of the interface
udp Displays User Datagram Protocol related traffic.
address = IP address of the interface.
address:port = IP address:port of the interface.
port = Port of the interface