Ip rip send-version, Ip route, Ip route -11 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 389
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
17-11
Configuration - PPTPC Mode
ip rip send-version
Use the PPTP Client ip rip send-version command to configure the send RIP messages on this
interface.
Syntax:
(config-pptpc-{n})# ip rip send-version {1|2-bcast|2-mcast
|none}
Example:
(config-pptpc-1)# ip rip send-version 2-bcast
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip route
Use the PPTP Client ip route command to configure the IP routing on this interface. To delete a route,
see no ip route command on page 17-17.
Syntax:
(config-pptpc-{n})# ip route
dest-ip-addr mask mask gateway
gateway metric metric
Example:
(config-pptpc-1)# ip route 192.168.100.200 mask 255.255.255.0
gateway 192.168.100.254 mask 125
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
1
Send RIP version 1.
2-bcast
Send RIP version 2 - Broadcast.
2-mcast
Send RIP version 2 - Multicast.
none
Set RIP version to none.
Field
Definition
dest-ip-addr
Enter the destination IP address.
mask
Enter the mask of the above address.
gateway
Enter the gateway IP address.
metric
Metric of IP network on this interface in Adit 3500 Routing Table.
Range is 0-255, with a default is 10.