Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 236)

9-8 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Dial Peer Trunk Mode
sip-authentication username
Use the Dial Peer sip-authentication username command to set the SIP ID.
Syntax:
(config-dpeer-trk)# sip-authentication username username
Example:
(config-dpeer-trk)# sip-authentication username
test-user-1
Supported Platforms: Adit 3500, MSR
strip-digits
Use the Dial Peer strip-digits command to configure the number of digits (or characters) to be stripped
off from the left most digits in the phone number. Possible usages include stripping off the area code,
or the 3-digit office prefix.
Syntax:
(config-dpeer-trk)# strip-digits number
Example:
(config-dpeer-trk)# strip-digits 4
Supported Platforms: Adit 3500, MSR
Field Definition
username The User ID to be used when responding to authentication requests.
Default is the User ID of the line.
Field Definition
number Range is based on the defined phone number. Default is set to 0.