Show config dynamic-dns, Show controller lcc – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 34
2-10
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
User Mode
show config dynamic-dns
Use the show config dynamic-dns command to display the dynamic DNS configuration.
Syntax:
> show config dynamic-dns
Example:
Adit 3500> show config dynamic-dns
dynamic-dns username admin hostname Host1
dynamic-dns interface eth-2
no dynamic-dns offline enable
no dynamic-dns wildcard enable
no dynamic-dns backup-mx enable
no dynamic-dns mail-exchanger
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
show controller lcc
Use the show controller lcc command to display the settings for a Link Cross Connect on the MSR
card.
Syntax:
> show controller lcc
number
Example:
Adit MSR> show controller lcc 1
Settings for interface LCC 1
---------------------------
Name : LinkCC 1
Device Name : LinkCC 1
Status : Operational
Network : WAN
Connection Type : Link Cross Connect
Connection : Data
Alarm Reporting : Enabled
Supported Platforms:
MSR
Field
Definition
number
Link Cross Connect number, 1-8.