Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 314)

13-18 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Serial Interface Mode
no ip primary-dns
Use the Serial Interface no primary-dns command to disable the primary DNS. To set the DNS
primary IP address, see ip primary-dns command on page 13-11.
Syntax:
(config-int-ser-{ n})# no ip primary-dns
Example:
(config-int-ser-1)# no ip primary-dns
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip rip
Use the Serial Interface no ip rip command to disable RIP on this interface. To enable RIP, see ip
rip command on page 13-11.
Syntax:
(config-int-ser-{ n})# no ip rip
Example:
(config-int-ser-1)# no ip rip
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip route
Use the Serial Interface no ip route command remove an IP route. To add a route, see ip route
command on page 13-12.
Syntax:
(config-int-ser-{ n})# no ip route dest-ip-addr gateway
Example:
(config-int-ser-1)# no ip route 192.168.100.200 192.168.100.254
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip secondary-dns
Use the Serial Interface no secondary-dns command to disable the secondary DNS. To enable the
secondary DNS, see ip secondary-dns command on page 13-13.
Syntax:
(config-int-ser-{ n})# no ip secondary-dns
Example:
(config-int-ser-1)# no ip secondary-dns
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
dest-ip-addr Enter destination IP address to remove.
gateway Enter gateway IP address to remove.