Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 251)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 11-7
Configuration - Ethernet Interface Mode
ip default-gateway
Use the Ethernet Interface ip default-gateway command to set the default gateway for the Ethernet
port.
Syntax:
(config-int-eth-{ n})# ip default-gateway address
Example:
(config-int-eth-1)# ip default-gateway 192.168.100.150
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
ip default-route
Use the Ethernet Interface ip default-route command to enable the default route. To disable the default
route, see no ip default-route command on page 11-17.
Syntax:
(config-int-eth-{ n})# ip default-route enable
Example:
(config-int-eth-1)# ip default-route enable
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
ip dhcp
Use the Ethernet Interface ip dhcp command to enable the use of DHCP options 66 and 67 to
autoconfigure the system. To disable DHCP, see no ip dhcp command on page 11-17.
Syntax:
(config-int-eth-{ n})# ip dhcp auto-provision
Example:
(config-int-eth-1)# ip dhcp auto-provision
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
address Enter a default gateway address to the Ethernet port.