Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 322)

14-2 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - IPSec Mode
aggressive-mode
Use the IPSec aggressive-mode command to set to aggressive mode, instead of main mode. To set to
main mode, see no aggressive-mode command on page 14-12.
Syntax:
(config-ipsec {n})# aggressive-mode
Example:
(config-ipsec-1)# aggressive-mode
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
authentication
Use the IPSec authentication command to specify a peer authentication method.
Syntax:
(config-ipsec {n})# authentication {pre-share shared-key|rsa-sig
rsa-signature|cert local-id peer-id}
Example:
(config-ipsec-1)# authentication pre-share mysecret
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
description
Use the IPSec description command to enter a description for the connection.
Syntax:
(config-ipsec {n})# description description
Example:
(config-ipsec-1)# description Boulder VPN IPSec0
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
pre-shared Specifies preshared keys as the authentication method.
shared-key- Enter the Pre-share key.
rsa-sig Specifies RSA signatures as the authentication method.
rsa-signature - Enter the RSA signature.
cert Set Certificate for local ID and Peer ID.
local-id - Enter the local ID.
peer-id - Enter the peer ID.
Field Definition
description Enter a description, with a maximum of 64 characters.