No tos ip, Release, Remote-admin – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 267: Renew, Release -23, Remote-admin -23 renew -23
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
11-23
Configuration - Ethernet Interface Mode
no tos ip
Use the Ethernet Interface no tos ip
command to disable IP TOS marking.
To enable TOS marking,
see tos command on page 11-25.
Syntax:
(config-int-eth-{
n})# no tos ip
Example:
(config-int-eth-1)# no tos ip
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
release
Use the Ethernet Interface release
command to release the DHCP lease.
Syntax:
(config-int-eth-{
n})# release
Example:
(config-int-eth-1)# release
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
remote-admin
Use the Ethernet Interface remote admin
command to enable Remote Access on this interface. To
disable remote access, see no remote-admin command on page 11-22.
Syntax:
(config-int-eth-{
n})# remote-admin enable
Example:
(config-int-eth-1)# remote-admin enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
renew
Use the Ethernet Interface renew
command to renew the DHCP lease.
Syntax:
(config-int-eth-{
n})# renew
Example:
(config-int-eth-1)# renew
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR