Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 181)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-55
Global Configuration Mode
Global Configuration Commands
remote-admin telnet
Use the remote-admin telnet command to allow remote administration via Telnet. To deny telnet
remote access, see no remote-admin telnet command on page 4-47.
CAUTION! A LLOWING REMOTE ADMINISTRATION IS A SECURITY RISK .
Syntax:
(config)# remote-admin telnet {primary-port|
primary-secure-port|secondary-port} {port port|enable}
Example:
(config)# remote-admin telnet primary-port enable
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
remote-admin udp-trace
Use the remote-admin udp-trace command to allow UDP traceroute queries. To deny UDP
traceroute queries, see no remote-admin udp-trace command on page 4-47.
CAUTION! A LLOWING REMOTE ADMINISTRATION IS A SECURITY RISK .
Syntax:
(config)# remote-admin udp-trace enable
Example:
(config)# remote-admin udp-trace enable
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
primary-port Primary Telnet port, default port 23
primary-secure-
port Secure Telnet over SSL port, default port 992
secondary-port Secondary Telnet port, default port 8023
port Enter a specific port to change from default ports listed above.
enable Enable port on telnet remote admin.