Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 313)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 13-17
Configuration - Serial Interface Mode
no ip ospf message-digest-key
Use the Serial Interface no ip ospf message-digest-key command to remove an old MD5 key. To
enable OSPF MD5 (Message-Digest) authentication, see ip ospf message-digest-key command on
page 13-9.
Syntax:
(config-int-ser-{ n})# no ip ospf message-digest-key key-id
Example:
(config-int-ser-1)# no ip ospf message-digest-key 1
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf priority
Use the Serial Interface no ip ospf priority command to set the router priority to the default setting
of priority 1. To set the router priority, which determines the designated router for this network, see
ip ospf priority command on page 13-10.
Syntax:
(config-int-ser-{ n})# no ip ospf priority
Example:
(config-int-ser-1)# no ip ospf priority
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf retransmit-interval
Use the Serial Interface ip ospf retransmit-interval command to restore the default value of 5
seconds. To define the interval of time between link state advertisement retransmissions for
adjacencies belonging to the interface, see ip ospf retransmit-interval command on page 13-10.
Syntax:
(config-int-ser-{ n})# no ip ospf retransmit-interval
Example:
(config-int-ser-1)# no ip ospf retransmit-interval
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf transmit-delay
Use the Serial Interface no ip ospf transmit-delay command to restore the default value of 1
second. To define the estimated time to transmit a link state update packet on the interface, see ip
ospf transmit-delay command on page 13-10.
Syntax:
(config-int-ser-{ n})# no ip ospf transmit-delay
Example:
(config-int-ser-1)# no ip ospf transmit-delay
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
key-id Enter an ID for this key. Range is 1-255.