Echo-cancel, Exit, Echo-cancel -5 end -5 exit -5 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 449
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
24-5
Configuration - Voice Port Trunk Mode
echo-cancel
Use the Voice Port Trunk echo-cancel command to enable Echo Cancellation on this trunk. To disable
Echo Cancellation, see no echo-cancel command on page 24-9.
Syntax:
(config-vport-trk-{
n})# echo-cancel enable
Example:
(config-vport-trk-1)# echo-cancel enable
Supported Platforms:
Adit 3500, MSR
end
Use the end command to exit the current Configuration mode.
Syntax:
(config-vport-trk-{
n})# end
Example:
(config-vport-trk-1)# end
#
Supported Platforms:
Adit 3500, MSR
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax:
(config-vport-trk-{
n})# exit
Example:
(config-vport-trk-1)# exit
(config)#
Supported Platforms:
Adit 3500, MSR