Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 289)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 12-19
Configuration - Multilink Interface Mode
no ppp on-demand
Use the Multilink Interface no ppp on-demand command to disable PPP on-demand. To enable
PPP on demand, see ppp on-demand command on page 12-22.
Syntax:
(config-int-mlink-{ n})# no ppp on-demand
Example:
(config-int-mlink-1)# no ppp on-demand
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ppp password
Use the Multilink Interface no ppp password command to remove the PPP password. To set the
PPP password, see ppp password command on page 12-22.
Syntax:
(config-int-mlink-{ n})# no ppp password
Example:
(config-int-mlink-1)# no ppp password
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ppp qos interleaving
Use the Multilink Interface no ppp qos interleaving command to disable PPP QoS interleaving.
To enable PPP QoS interleaving, see ppp qos-interleaving command on page 12-23.
Syntax:
(config-int-mlink-{ n})# no ppp qos interleaving
Example:
(config-int-mlink-1)# no ppp qos interleaving
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ppp username
Use the Multilink Interface no ppp username command remove the PPP username. To set a PPP
user, see ppp username command on page 12-24.
Syntax:
(config-int-mlink-{ n})# no ppp username
Example:
(config-int-mlink-1)# no ppp username
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR