Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 102)

3-44 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Privileged Mode
show ip ospf interface
Use the show ip ospf interface command to display OSPF related interface information.
Syntax:
# show ip ospf interface {ethernet port|serial port|multilink
port}
Example:
adit 3500# show ip ospf interface ethernet 1
Ethernet 1 is up, line protocol is up
Internet Address 192.168.254.202, Mask 255.255.255.0, Area 0.0.0.0
AS 201, Router ID 192.168.99.1, Network Type BROADCAST, Cost: 10
Transmit Delay is 1 sec, State OTHER, Priority 1
Designated Router id 192.168.254.10, Interface address 192.168.254.10
Backup Designated router id 192.168.254.28, Interface addr 192.168.254.28
Timer intervals configured, Hello 10, Dead 60, Wait 40, Retransmit 5
Hello due in 0:00:05
Neighbor Count is 8, Adjacent neighbor count is 2
Adjacent with neighbor 192.168.254.28 (Backup Designated Router)
Adjacent with neighbor 192.168.254.10 (Designated Router)
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
ethernet port Display information on the Ethernet interface.
port = 1 or 2
serial port Display information on the serial interface.
Adit 3104: Value must be 1.
Adit 3500: Range = 1-4.
MSR: Range = 1-8.
multilink port Display information on the Multilink interface.
Adit 3104, Adit 3500, MSR: Value must be 1