Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 156)

4-30 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
log security notify
Use the log security notify command to set the remote security notify level.
Syntax:
(config)# log security notify {error|info|ip-address address
|none|warn}
Example:
(config)# log security notify warn
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
log sip
Use the log sip command to configure SIP logging. To stop a SIP log, see no log sip command on
page 4-44.
Syntax:
(config)# log sip {buffer-fill {0|1}|buffer-size kilobytes
|display number|enable|level {detail|non-detailed}}
Example:
(config)# log sip buffer-fill 0
Supported Platforms: Adit 3104, Adit 3500, MSR
Field Definition
error Notify for error level.
info Notify for information level.
ip-address address Enter IP address of remote system to notify.
none No notification.
warn Notify for warning level.
Field Definition
buffer-fill {0|1} Define the method of loading the buffer.
0 = Circular Buffer - the buffer will store a continuous stream of data
by starting again at the beginning of the buffer after reaching the end.
Default.
1 = Fill Until Full - the buffer will fill until it is full. The user will
have to clear the log manually.
buffer-size kilobytes Configure the SIP log size. Range is 1 - 250 KB, with a default of 100
KB.
display number Defines the number of lines per message. 0 = full
enable Enable SIP logging.
level Defines the logging level.
detailed - Set logging level to detail.
non-detailed - Set logging level to non-detail