Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 229)

C
HAPTER
9
Configuration - Dial Peer Trunk Mode
The Dial Peer Trunk Configuration commands allow the user to configure the Dial Peer Trunk
parameters.
Enter this sub-group with the (config)# dial-peer voice pots trunk trunk dest-port command from the
Configuration mode.
The Dial Peer Trunk commands are represented by the (config-dpeer-trk)# prompt.
Note: The Dial Peer Trunk option is not supported on the Adit 3104.
Dial Peer Trunk Commands
• codec preference
• destination-pattern
• do
• end
• exit
• fax-protocol
• history
• modem-protocol
• no commands
• prefix
• sip-authentication
• strip-digits