Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 414)

19-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - RADIUS Mode
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file. This command can be entered in any configuration mode with the same result.
Syntax:
(config-radius)# end
Example:
(config-radius)# end
#
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax:
(config-radius)# exit
Example:
(config-radius)# exit
(config)#
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
history
Use the history command to display commands that have been entered in this session. This command
can be entered in any configuration mode.
Syntax:
(config-radius)# history
Example:
(config-radius)# history
exit
authentication chap
host
host 192.168.1.1
key
history
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR