Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 171)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-45
Global Configuration Mode
Global Configuration Commands
no network-object
Use the no network-object command to remove network objects. To enable a network object, see
network-object command on page 4-35.
Syntax:
(config)# no network-object id object-id type {hostname
hostname|ip-address address|mac-address mac-address}
Example:
(config)# no network-object id 1 type ip-address 192.168.1.200
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no port-trigger-service
Use the no port-trigger-service command to remove a port-triggering entry. To configure port
triggering, see port-trigger service command on page 4-53.
Syntax:
(config)# no port-trigger-service name
Example:
(config)# no port-trigger-service servicename2
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no pptpc
Use the no pptpc command to disable the VPN PPTP client. To enter the VPN PPTP Client
configuration mode, see the pptpc command on page 4-53.
Syntax:
(config)# no pptpc {pptpc connection-id|address address}
Example:
(config)# no pptpc pptpc 1
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
object-id Enter the numerical ID of the Network Object.
hostname Enter the host name of the Network Object.
address Enter the IP address of the Network Element.
mac-address Enter the MAC address of the Network Element (xx:xx:xx:xx:xx:xx)
Field Definition
name Enter service name.
Field Definition
connection-id Enter the name of a connection.
address Enter a destination IP address.