Dynamic-dns, Dynamic-dns backup-mx, Dynamic-dns interface – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 140: Dynamic-dns -14
4-14
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
dynamic-dns
Use the dynamic-dns commands to configure the DNS Dynamic entries. To disable Dynamic DNS, see
no dynamic-dns command on page 4-39.
dynamic-dns backup-mx
Use the dynamic-dns backup-mx command to enable the Dynamic DNS backup MX.
Syntax:
(config)# dynamic-dns backup-mx enable
Example:
(config)# dynamic-dns backup-mx enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
dynamic-dns interface
Use the dynamic-dns interface command to define the Dynamic DNS connection to update.
Syntax:
(config)# dynamic-dns interface {eth-2|mlink-1|ser-n}
Example:
(config)# dynamic-dns interface ser-1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
eth-2
Select Ethernet port 2.
mlink-1
Select Multilink port 1.
ser-n
Select serial interface 1-4.