Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 276)

12-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Multilink Interface Mode
ip default-route
Use the Multilink Interface ip default-route command to enable the default route. To disable the default
route, see no ip default-route command on page 12-14.
Syntax:
(config-int-mlink-{ n})# ip default-route enable
Example:
(config-int-mlink-1)# ip default-route enable
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
ip mtu
Use the Multilink Interface ip mtu command to set the Maximum Transmission Unit. Sets the largest
packet size (bytes) the network will allow to transmit.
Syntax:
(config-int-mlink-{ n})# ip mtu {size|auto}
Example:
(config-int-mlink-1)# ip mtu auto
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
size Allows the user to set the Maximum Transmission Unit (MTU).
size = range of 576 to 1500 bytes.
auto Auto sets the MTU at 1500 bytes.