Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 213)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 7-3
Configuration - DHCP Pool Ethernet Mode
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file. This command can be entered in any configuration mode with the same result.
Syntax:
(config-dhcp-eth-{ n})# end
Example:
(config-dhcp-eth-1)# end
#
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
end-address
Use the DHCP end-address command to define the DHCP end address. This command works with the
start-address (start IP address) to define the number of IP addresses in the DHCP pool. This also limits
the number of hosts that may be connected to the network in this subnet. End-address defines the last
IP address that may be assigned in this subnet.
Syntax:
(config-dhcp-eth-{ n})# end-address address
Example:
(config-dhcp-eth-1)# end-address 192.168.1.255
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax:
(config-dhcp-eth-{ n})# exit
Example:
(config-dhcp-eth-1)# exit
Example:
(config)#
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
address The ending address of the client address pool, in the form of
xxx.xxx.xxx.xxx, where xxx is between 0-255