Controller lcc, Controller t1, Controller lcc -7 controller t1 -7 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 133
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
4-7
Global Configuration Mode
Global Configuration Commands
controller lcc
Use the controller lcc command to allow access to the Controller LCC configuration commands. See
Chapter 5, Configuration - LCC Controller Mode for commands in this mode.
Syntax:
(config)# controller lcc
number
Example:
(config)# controller lcc 1
(config-cont-lcc-1)#
Supported Platforms:
MSR
controller t1
Use the controller t1 command to allow access to the Controller T1 configuration commands. See
Chapter 6, Configuration - T1 Controller Mode for commands in this mode.
Syntax:
(config)# controller t1
port
Example:
(config)# controller t1 1
(config-cont-t1-1)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500
Field
Definition
number
Selects the Link Cross Connect. Range = 1-8
Field
Definition
port
Selects the T1 (DS1) port.
Adit 3104 Range = 1
Adit 3500 Range 1 - 4