Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 21)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 1-3
Introduction
Overview
Prompt Identifier
When you initiate a CLI session it will open in User mode, which is indicated by the ">" prompt. At any
time you can quickly determine which mode you are in by the prompt.
User Mode
In User Mode, the operator is allowed to view only limited information (not able to modify
configurations). Editing the configuration requires you to be in Privileged mode.
Privileged Mode
Privileged mode requires a password, and allows the operator to enter the Configuration mode.
Command
Mode Access Method Prompt Displayed Exit Method
User Login adit 3104>
adit 3200>
adit 3500>
adit MSR> Use the logout command
Privileged From User mode, enter the
enable command adit 3104#
adit 3200#
adit 3500#
adit MSR# Use the exit or end command.
Global
Configuration From Privileged mode, enter
the configure terminal
command. adit 3104 (config)#
adit 3200 (config)#
adit 3500 (config)#
adit MSR (config)# Use the exit or end command, or
press Ctrl-z.