No ip proxy-arp, No ip rip, No ip route – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 265: No ip secondary-dns
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
11-21
Configuration - Ethernet Interface Mode
no ip proxy-arp
Use the Ethernet Interface no ip proxy-arp command to disable the proxy ARP on this interface.
To enable proxy ARP, see ip proxy-arp command on page 11-13.
Syntax:
(config-int-eth-{
n})# no ip proxy-arp
Example:
(config-int-eth-1)# no ip proxy-arp
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip rip
Use the Ethernet Interface no ip rip command to disable RIP on this interface.
To enable RIP, see
Syntax:
(config-int-eth-{
n})# no ip rip
Example:
(config-int-eth-1)# no ip rip
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip route
Use the Ethernet Interface no ip route command remove an IP route. To add a route, see ip
route command on page 11-15.
Syntax:
(config-int-eth-{
n})# no ip route dest-ip-addr gateway
Example:
(config-int-eth-1)# no ip route 192.168.100.200 192.168.100.254
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip secondary-dns
Use the Ethernet Interface no secondary-dns command to disable the secondary DNS. To enable
the secondary DNS, see ip secondary-dns command on page 11-16.
Syntax:
(config-int-eth-{
n})# no ip secondary-dns
Example:
(config-int-eth-1)# no ip secondary-dns
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
dest-ip-addr
Enter destination IP address to remove.
gateway
Enter gateway IP address to remove.