No ip ospf hello-interval, No ip ospf message-digest-key, No ip ospf priority – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 393
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
17-15
Configuration - PPTPC Mode
no ip ospf hello-interval
Use the PPTP Client no ip ospf hello-interval command to reset the interval of time to the default
setting of the path cost to the default setting of 10 seconds. To define the interval of time between
hello packets sent on the interface, see ip ospf hello-interval command on page 17-8.
Syntax:
(config-pptpc-{n})# no ip ospf hello-interval
Example:
(config-pptpc-1)# no ip ospf hello-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf message-digest-key
Use the PPTP Client no ip ospf message-digest-key command to remove an old MD5 key. To
enable OSPF MD5 (Message-Digest) authentication, see ip ospf message-digest-key command on
page 17-8.
Syntax:
(config-pptpc-{n})# no ip ospf message-digest-key
key-id
Example:
(config-pptpc-1)# no ip ospf message-digest-key 1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf priority
Use the PPTP Client no ip ospf priority command to set the router priority to the default setting of
priority 1. To set the router priority, which determines the designated router for this network, see ip
ospf priority command on page 17-9.
Syntax:
(config-pptpc-{n})# no ip ospf priority
Example:
(config-pptpc-1)# no ip ospf priority
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
key-id
Enter an ID for this key. Range is 1-255.