Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 285)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 12-15
Configuration - Multilink Interface Mode
no ip ospf authentication-key
Use the Multilink Interface no ip ospf authentication-key command to remove a password to be
used by neighboring routers, that are using OSPF’s simple password authentication. To assign a
password, see ip ospf authentication-key command on page 12-8.
Syntax:
(config-int-mlink-{ n})# no ip ospf authentication
Example:
(config-int-mlink-1)# no ip ospf authentication-key
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf cost
Use the Multilink Interface no ip ospf cost command to reset the cost path to the default setting of
0. To define the cost of sending a packet on this Multilink interface, see ip ospf cost command on
page 12-8.
Syntax:
(config-int-mlink-{ n})# no ip ospf cost
Example:
(config-int-mlink-1)# no ip ospf cost
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf dead-interval
Use the Multilink Interface no ip ospf dead-interval command to reset the interval of time to the
default setting of 40 seconds. To define the interval of time that no hello packets have been seen
before neighbors declare the router down, see ip ospf dead-interval command on page 12-8.
Syntax:
(config-int-mlink-{ n})# no ip ospf dead-interval
Example:
(config-int-mlink-1)# no ip ospf dead-interval
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf disable
Use the Multilink Interface no ip ospf disable command to enable OSPF processing on this
interface. To disable OSPF on this interface, see ip ospf disable command on page 12-9.
Syntax:
(config-int-mlink-{ n})# ip ospf disable all
Example:
(config-int-mlink-1)# ip ospf disable all
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR