Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 286)

12-16 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Multilink Interface Mode
no ip ospf hello-interval
Use the Multilink Interface no ip ospf hello-interval command to reset the interval of time to the
default setting of the path cost to the default setting of 10 seconds. To define the interval of time
between hello packets sent on the interface, see ip ospf hello-interval command on page 12-9.
Syntax:
(config-int-mlink-{ n})# no ip ospf hello-interval
Example:
(config-int-mlink-1)# no ip ospf hello-interval
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf message-digest-key
Use the Multilink Interface no ip ospf message-digest-key command to remove an old MD5 key.
To enable OSPF MD5 (Message-Digest) authentication, see ip ospf message-digest-key command
on page 12-9.
Syntax:
(config-int-mlink-{ n})# no ip ospf message-digest-key key-id
Example:
(config-int-mlink-1)# no ip ospf message-digest-key 1
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf priority
Use the Multilink Interface no ip ospf priority command to set the router priority to the default
setting of priority 1. To set the router priority, which determines the designated router for this
network, see ip ospf priority command on page 12-10.
Syntax:
(config-int-mlink-{ n})# no ip ospf priority
Example:
(config-int-mlink-1)# no ip ospf priority
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
key-id Enter an ID for this key. Range is 1-255.