Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 288)

12-18 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Multilink Interface Mode
no ip route
Use the Multilink Interface no ip route command remove an IP route. To add a route, see ip route
command on page 12-12.
Syntax:
(config-int-mlink-{ n})# no ip route dest-ip-addr gateway
Example:
(config-int-mlink-1)# no ip route 192.168.100.200
192.168.100.254
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip secondary-dns
Use the Multilink Interface no secondary-dns command to disable the secondary DNS. To enable
the secondary DNS, see ip secondary-dns command on page 12-13.
Syntax:
(config-int-mlink-{ n})# no ip secondary-dns
Example:
(config-int-mlink-1)# no ip secondary-dns
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ppp authentication
Use the Multilink Interface no ppp authentication command disable PPP authentication. To
enable PPP authentication, see ppp authentication command on page 12-21.
Syntax:
(config-int-mlink-{ n})# no ppp authentication
Example:
(config-int-mlink-1)# no ppp authentication
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ppp encryption
Use the Multilink Interface no ppp encryption command to disable PPP encryption. To enable PPP
encryption, see ppp encryption command on page 12-21.
Syntax:
(config-int-mlink-{ n})# no ppp encryption
Example:
(config-int-mlink-1)# no ppp encryption
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
dest-ip-addr Enter destination IP address to remove.
gateway Enter gateway IP address to remove.