Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 193)

C
HAPTER
5
Configuration - LCC Controller Mode
The LCC (Link Cross-Connect) Controller Configuration commands allow the user to configure the
Link Cross-Connect parameters for the MSR card.
Note: The LCC Controller Configuration mode is supported by the MSR card only. For Controller
Configuration commands for the Adit 3000 series, see Chapter 6, Configuration - T1 Controller Mode.
This sub-group is entered with the (config)# controller lcc command from the Configuration mode.
The LCC Controller commands are represented by the (config-cont-lcc-{n})# prompt.
LCC Controller Commands
• description
• do
• end
• exit
• history
• no command
• shutdown