Sip-authentication, Sip-authentication enable, Sip-authentication password – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 228: Sip-authentication username, Sip-authentication -10
8-10
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Dial Peer FXS Mode
sip-authentication
Note: To disable this SIP authentication, see the no sip-authentication command on page 8-9.
sip-authentication enable
Use the Dial Peer sip-authentication enable command to enable SIP.
Syntax:
(config-dpeer-fxs)# sip-authentication enable
Example:
(config-dpeer-fxs)# sip-authentication enable
Supported Platforms:
Adit 3104, Adit 3500, MSR
sip-authentication password
Use the Dial Peer sip-authentication password command to set the SIP password.
Syntax:
(config-dpeer-fxs)# sip-authentication password
password
Example:
(config-dpeer-fxs)# sip-authentication password
test-password
Supported Platforms:
Adit 3104, Adit 3500, MSR
sip-authentication username
Use the Dial Peer sip-authentication username command to set the SIP ID.
Syntax:
(config-dpeer-fxs)# sip-authentication username
username
Example:
(config-dpeer-fxs)# sip-authentication username
test-user-1
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field
Definition
password
The password to be used when responding to authentication requests.
Field
Definition
username
The User ID to be used when responding to authentication requests.
Default is the User ID of the line.